Electronics Boxes
Electronics Boxes for Boat T-Tops
An electronics box is a one of the most popular accessory for upgrading center console boat t-tops. An e-box is an ideal upgrade that increases a boat's storage space. By name, electronics boxes are intended for mounting electronics like a CB radio, GPS or stereo unit. However, there is plenty of space to keep other valuables like a phone, wallet or important papers high, dry and locked up. They are designed to be compatible all Stryker T-Top models . The large sweeping leading edge, molded tapers and curved edges make our e-boxes not only attractive, but also more aerodynamic to keep wind noise and air resistance to a minimum.
Electronics Box Features
Strongest Boat T-Top Electronics Boxes
Stryker has innovated past the old industry standard of using fiberglass for the body of the electronics box and, instead, have developed and tested the use of a thick, impact resistant, rotomolded composite material. It's very similar to the shell of an ice chest that is known to be incredibly tough. This difference in material and manufacturing is a big upgrade that provides a greatly improved strength, consistency of wall thickness, and a longer lifespan. The most common drawbacks of fiberglass electronics boxes include it being more prone to cracking, yellowing or the gel coat deteriorating over time. Here at Stryker, we have invested in and perfected the rotomolding process that rotates as the material cools so that each unit is consistently thick.
Simple to Install
Mounting a Stryker T-Tops electronics box is very simple and can be done in only about 15-30 minutes. There are four mounting points with one at each outer corner. After installing the t-top, hold up the electronics box where it will be mounted and mark each hole making sure it's square. Proceed by drilling holes up through the tubing the use the included stainless steel mounting hardware to secure it in place. It's important to mention that you'll want to avoid drilling through your expensive canvas canopy. We advise either roping on the canvas after installing the e-box or placing at least a two inch block of wood as a buffer above the tube and under the canopy. Wiring, if needed, simply involves drilling an exit hole on the box then routing either inside the t-top's tubing or along the exterior. To keep everything water tight, we recommend using a fitted rubber grommet on the hole with wires feeding through and/or caulking with marine grade silicone sealant.
Features & Specifications
SB200 Standard T-Top Electronics Box:
• 9.5"H x 25.25"W x 22.8"L
• Rotomolded for superior strength and longevity
• White or black color
• 1/8-inch thick smoked Plexiglass door
• Stainless steel spring hinges
• Foam gasket seal
• Lockable door
• Comes with stainless hardware for mounting
• Easy installation
SB330L T-Top Electronics Box with 2 Speakers and LED Dome Light:
• 9 1/2"H x 25 3/8"W x 26"L
• Fusion 4" Marine 2-Way Speakers (120 W)
• Efficiency (1W/1M): 87dB
• Frequency Response: 90Hz-22kHz
• Impedance: 4 Ohms
• Peak Power (Watts): 120
• LED Dome Light with 280 lumen output
• Rotomolded for superior strength and longevity
• 1/8" thick smoked Plexiglass door
• Stainless steel spring hinges
• Foam gasket seal
• Lockable door
• White interior with grey foam covering light/speaker wiring
• Comes with stainless hardware for mounting
• Easy installation